Aligned the yoke gear pins to their closest position.Slid "Yoke, Left.stl" over the pin on "Gear, Yoke, Left.stl" and slid the assembly into "Base.stl".Slid "Yoke, Right.stl" over the pin on "Gear, Yoke, Right.stl", slid the assembly into "Base.stl", then secured it in place using "Axle, Gear, Yoke (1.5m 32t).stl".To assemble the base, I performed the following steps: The model also uses threaded assembly thus an M8 by 1.25 tap and die will assist with thread cleaning if necessary. I used small jewelers files and plenty of patience to perform this step. Carefully file all edges that contacted the build plate to make absolutely certain that all build plate "ooze" is removed and that all edges are smooth. Depending on you printer, your printer settings and the colors you chose, more or less trimming, filing, sanding and/or polishing may be required. all parts as necessary for smooth movement of moving surfaces, and tight fit for non moving surfaces. Prior to assembly, test fit and trim, file, sand, polish, etc. This is an ultra high precision 3D print and assembly model using at times very small precision 3D printed parts in very tight spaces. 15mm layer height, 20% infill and no supports, unless noted otherwise: I 3D printed the following parts in PLA at.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |